Udemy – Complete Electronics Course – From Idea to PCB and Prototype

Learn the complete workflow of embedded hardware development — from a raw concept to a fully manufacturable PCB — using a professional ECAD environment and real engineering methods applied to a real project.

What you will build: A fully designed embedded board, developed step by step through every phase of the hardware engineering process, the same way professional engineers do it in the industry.

Course structure:

• Requirements & Architecture — Start by defining clear system requirements: power budgets, communication interfaces, mechanical constraints, and operating conditions. Build a block diagram that maps every functional module before writing a single net.
• Schematic Design — Place and wire components correctly, structure hierarchical sheets, apply decoupling strategies, manage power and signal integrity, and produce a clean, annotated schematic ready for layout.
• PCB Layout — Translate your schematic into a routed board. Learn component placement strategy, trace width calculations, differential pair routing, ground plane management, design rule checks (DRC), and Gerber file and BOM preparation for fabrication.
• Component Selection — Read and interpret datasheets, compare key electrical parameters, understand part tolerances and derating, and confidently source components on different suppliers.